Pool Pump, Filter and Timer Repair in Frisco and Collin County
Diagnostic visit $95; pump motor replacement from $450
Six in the morning, the timer clicks on, and instead of the usual rush of water the pump just hums. Or it starts, runs for a minute, and the basket fills with air. Or the breaker trips before the pump does anything at all. In Collin County the pump runs more hours a year than in most of the country, and it is the part that fails first.
Pump problems we see every week in Frisco
- Hums but does not spin. Start capacitor or seized bearings. Capacitor swaps are done on the spot.
- Runs loud and screeches. Bearings. On a motor under about five years old we replace the motor. On an older pump a whole new unit is usually the better buy.
- Loses prime or runs with air in the basket. A suction-side air leak: lid o-ring, drain plug, cracked lid, or a line leak under the deck.
- Leaks under the motor. The shaft seal, which lets water into the motor if ignored. A seal is a cheap fix until the motor rusts out.
- Trips the breaker. Shorted windings, a wet junction box, or a seal leak that reached the motor. Wiring a new pump, salt cell or heater, and the bonding grid around the pool, is electrical work that Texas requires a TDLR-licensed electrician to do. We bring one in for anything past the equipment's own disconnect, and a wet junction box or tripping breaker is checked before any motor is replaced.
- Variable-speed drive error codes. Many are a loose connection or an overheated drive on a south-facing pad. Some need a drive board.
Filter tanks, valves and plumbing
Cartridge, DE and sand filters all fail in similar ways. A cracked tank, a tank o-ring that sprays at the clamp band, or a multiport valve gasket that sends water out the waste line. Sometimes just a pressure gauge stuck at zero. We rebuild valves, replace o-rings and clamps, and replace tanks that are past their rated pressure life. Filter cleaning itself is on its own page.
Plumbing repairs cover cracked unions, leaking check valves on the heater bypass, and the brittle PVC that splits after years of sun. Every fitting goes back with the right primer and glue, not the hardware store kit.
Timers and automation
A mechanical timer that stopped turning, trippers that will not hold, or a digital automation panel that lost its schedule in a power outage. We replace timer motors, reset and reprogram automation, and wire in a freeze sensor where the equipment needs one. If you are tired of walking to the pad to switch modes, a basic automation panel with phone control can usually be added to existing equipment.
How the repair visit works
- Describe the symptom when you call. If the pump is tripping the breaker or leaking onto the motor, switch it off at the timer or breaker. That keeps the motor alive until we arrive.
- The tech runs the system, checks voltage, amps and suction pressure, and gives you a written finding and price before touching anything.
- Common capacitors, seals, o-rings, gauges and timer motors are on the truck. Motors and pumps for the common brands are usually available the same or next day.
- After the repair the tech sets the run schedule for the season and confirms the pool is turning over.
Pricing
The diagnostic visit is $95 and is applied to the repair when you go ahead. Pump motor replacements start at $450. A new variable-speed pump installed is quoted by model. Timer motors, capacitors and seals are flat-rate parts listed on the invoice. Anything past the equipment's own disconnect is electrical work for a licensed electrician, and we bring one in.
If the pump is humming or tripping the breaker this morning, switch it off at the timer and call (972) 640-4665. We cover Frisco and the rest of Collin County, and the common capacitors and seals ride on the truck.